SKL-30-TTLL-E

Product information "SKL-30-TTLL-E"

Pre-assembled safety contact bar SKL-30-TTLL-E with 2 sealing lips as end bar including C-profile Al 25-14 (optional also without)

Identical successor to SE 25.30 TTLL end bar Art.No. 114-0102 with new description

The safety contact bar SKL-30-TTLL-E is required for closing edge safety at crushing and shearing points. It is used on gates, machines, and handling equipment to protect people and material. It consists of the contact sensor and the aluminum profile. The basis for constant function monitoring is the resting current principle applied here. The last safety contact bar in a possible series connection receives a termination resistor that is continuously measured by evaluation electronics. This setup also checks the entire wiring for short circuits and wire breaks.

End bar: One side with termination resistor or diode, which is directly evaluated by most gate controllers, the other side is pre-assembled with cable length between 0.5 m to 10 m.

Length: The safety contact bar is manufactured to the required length from 100 mm to a maximum of 15 m. Please specify the required length during the ordering process.

Technical data:

Height: 30 mm (48 mm with lips)
Width: 25 mm
Switching voltage: max. 24 V
Switching current: 0.1 A at maximum switching voltage
Connection 1: Cable 0.25 mm², length 0.5 ... 10 m
Connection 2: Resistor 8k2, alternatively 1k2 or diode or direct switching
Operating temperature: -25 °C ... +55°C
Rubber profile: TPE black, hardness approx. 68 Shore A
C-profile: Alu-C-profile AL 25-14 (optional also without)
Actuation distance: 10 mm
Actuation force: 54.3 N
Overrun distance up to 250 N: 15.5 mm
Overrun distance up to 400 N: 18.1 mm

Actuation values according to DIN EN 1760-2:2001 / Measuring point 1 / 10 mm/s / 20°

Product information "SKL-30-TTLL-E"

Questions to the product?

Product safety information