SKL-30-TTLL-D

Product information "SKL-30-TTLL-D"

Factory pre-configured safety contact strip SKL-30-TTLL-D with 2 sealing lips as a passage strip including C-profile Al 25-14 (optional also without)

Equivalent successor to SE 25.30 TTLL passage strip Art.No. 114-0103 with new designation

The safety contact strip SKL-30-TTLL-D is used for closing edge protection at pinch and shear points. It is installed on gates, machines, and handling devices to protect people and material. It consists of the contact sensor and the aluminum profile. The basis for continuous function monitoring is the idle current principle used here. The last safety contact strip in a possible series connection receives a termination resistor or termination diode, which is continuously measured by evaluation electronics. This design also checks the entire wiring path for short circuits and wire breaks.

Passage strip: Both sides standardly configured with 2 cables ranging from 0.3 to 15 m in length including C-profile (optional also without)

Length: The safety contact strip is precisely manufactured to the required length in the range of 100 mm to a maximum of 15 m. Please specify the required length during the ordering process.

Technical Data:

Height: 30 mm (48 mm with sealing lips)
Width: 25 mm
Switching voltage: max. 24 V
Switching current: 0.1 A at maximum switching voltage
Connection 1: Cable 2 x 0.25 mm², length 0.5 ... 10 m
Connection 2: Cable 2 x 0.25 mm², length 0.5 ... 10 m
Operating temperature: -25 °C ... +55°C
Rubber profile: TPE black, hardness approx. 68 Shore A
C-profile: Alu-C-profile AL 25-14 (optional also without)
Response distance: 10 mm
Response force: 54.3 N
After-run distance up to 250 N: 15.5 mm
After-run distance up to 400 N: 18.1 mm

Activation values according to DIN EN 1760-2:2001 / Measuring point 1 / 10 mm/s / 20°

Product information "SKL-30-TTLL-D"

Questions to the product?

Product safety information